In SAP QM, in order for inspection lots with accepted results recordings to be subjected to the Auto UD program, what should be setup ?
(only one answer)
A) Set the 'Auto UD' indicator in the Inspection Plan header.
B) Set the 'Auto UD' indicator in the QM Control key assigned to the Material Master.
C) Set the 'Auto UD' indicator in the Inspection Type detail in the Material Master QM view.
D) Set the 'Auto UD' indicator while performing Results Recording.
E) Set the 'Auto UD' indicator in the Quality Info Record.
.
(only one answer)
A) Set the 'Auto UD' indicator in the Inspection Plan header.
B) Set the 'Auto UD' indicator in the QM Control key assigned to the Material Master.
C) Set the 'Auto UD' indicator in the Inspection Type detail in the Material Master QM view.
D) Set the 'Auto UD' indicator while performing Results Recording.
E) Set the 'Auto UD' indicator in the Quality Info Record.
.
Answer: C
ReplyDeleteIn the IMG, the plant parameter provides the time lapse from RR before the Auto UD can take place for an inspection lot.
ReplyDeleteHowever, the following pre-requisites must be fulfilled:
. There are no rejected chacteristics at resukts recording.
. The required inspection characteristics are completed without rejections.
. They shoukd not be any Defect recordings for the inspection lot.
. The material master QM view's inspection type detail was set with the 'Auto UD' indicator.
.