Question no 4067 : Material Specification Attributes

In SAP Quality Management (as at S/4HANA 2023), which of the following features are not possible for direct assignment in the "Material Specification"?

(more than one answers)

A) Sampling Procedure
B) Dynamic Modification Rule.
C) Sample Drawing Procedure
D) Inspection Point.
E) Inspection Method.
.

Answer: B, C, D, E

The following can be assigned to Material Specification:
. Master Inspection Characteristics (with Version)
. Sampling Procedure

Dynamic Modification Rule:  can be assigned at three different levels: the inspection plan header (for lot-level or inspection type level) (QP02) , the inspection plan characteristic (QP02), or the material master's inspection type setup in the QM data view (MM02) .

Sample Drawing Procedure: is assigned to the inspection plan header (transaction QP02) to define the process for creating and drawing samples from an inspection lot. You can also assign it to operations within an inspection plan to define different sampling requirements for each stage of the process.

Inspection Points: can be assigned at the header of an inspection plan (QP02) or to the master recipe's QM data (QS23), enabling results recording at specific instances within an inspection operation. You can also assign inspection points directly to task lists header of (routing or master recipe) (CA02 or C202), defining the split for quantity-based or time-based inspections. The inspection is also assign ot the maintenance task list header (IA06) for the Calibration scenario. 

Inspection Method: can be assigned to Master Inspection Characteristics (QS23) and directly to an Inspection Characteristic in an Inspection Plan (Task List) (QP02). It serves as a master record that describes the procedure for inspecting a characteristic and can be reused across different materials and plants.